Xiaomi MI Redmi note 3 / PRO Mod to use 2 sims & 1 Micro SD card at a time
***DISCLAIMER***
Try at your own risk. If you do it properly with care you
AS ALWAYS DO ON YOUR OWN RISK. HARDWARE MOD can potentially damage or burn your device
don´t come to cry if your phone xploded,nuclear blasted or melted
Is not that hard and will be easy for less experienced hobbyists
So here we go : (pictures are bellow)
--Micro-SIM heated above a under cup of HOT coffee or HOT tea or HARIRA for a few seconds until the plastic was soft.
--gently bent down the soft plastic then and slide the gold-plated part(chip with contact plate). This part bend in any case! Now you have a MICRONANO-SIM (still smaller than Nano-SIM).
--Super Glue MICRONANO SIM on the SD card.the sim card will be a little over the edge of the SD card, as the drawer of the phones it has a recess. (SIM is 90 degrees rotated to the SD card inserted) Had me the exact position of the SIM previously penciled in pencil on the SD card. Recommendation: During the gluing, cover the terminals of the SD card with tape to prevent superglue boils.
--DONE
Try at your own risk. If you do it properly with care you
AS ALWAYS DO ON YOUR OWN RISK. HARDWARE MOD can potentially damage or burn your device
don´t come to cry if your phone xploded,nuclear blasted or melted
Is not that hard and will be easy for less experienced hobbyists
So here we go : (pictures are bellow)
--Micro-SIM heated above a under cup of HOT coffee or HOT tea or HARIRA for a few seconds until the plastic was soft.
--gently bent down the soft plastic then and slide the gold-plated part(chip with contact plate). This part bend in any case! Now you have a MICRONANO-SIM (still smaller than Nano-SIM).
--Super Glue MICRONANO SIM on the SD card.the sim card will be a little over the edge of the SD card, as the drawer of the phones it has a recess. (SIM is 90 degrees rotated to the SD card inserted) Had me the exact position of the SIM previously penciled in pencil on the SD card. Recommendation: During the gluing, cover the terminals of the SD card with tape to prevent superglue boils.
--DONE